tech notes 5:
X, Y, or Z KD UPPER or LOWER BOUNDS ERROR:
Errors caused by the VCMD parameter not being set correctly for the axis drive. See procedure: check drive offsets follow the portion for following error check.

CATI DIGITIZER CPU TYPE
Turn power off to the Digitizer and remove the cover Look at the boards in the digitizer. ADVANTECH CPU CHECK: The CPU board should be only full length board in the card rack. (It should have 2 ribbon cables attached to it.) There should be 1 mini DIN and 2 male 9 pin D-Sub connectors mounted on the bulkhead plate at the end of the board.

TEXAS MICRO SYSTEMS:
The CPU could be shipped in either a single full length board or a dual full length board set. On the full length board without ribbon cables there should be a white push button without any connectors mounted on the bulkhead plate at the end of the board.

FARADAY:
The CPU could be shipped in either a single full length board or a dual full length board set. On the full length board without ribbon cables there should be a 9 pin D-Sub female connector mounted on the bulkhead plate at the end of the board.

NOTE: Some Faraday CPU boards will have a red push button in addition to the 9 pin connector mounted on the bulkhead plate.
Home
Home
Products
Products
Contact
Contact


CNC Duplicators
CPRCAT I
CPRCPR
CAT LinkCATLink
CAT IICAT II
CAT LinkCATLink
CNC Software
Machine MateMachine Mate
Machine MateCamSoft
Tech Notes
Tech NotesCommon Problems
Current VersionCurrent Version
Drive OffsetsDrive Offsets
High CurrentHigh Current
HP 150 TroubleHP 150 Trouble
Oscillation in ServoOscillation in Servo
Oscillation in TraceOscillation in Trace
Run AwayRun Away
Company Info
MissionProfile
TimelineTimeLine
.
formerly Incon Systems Limited